NODIZ Pro with Un-terminated Wiring Loom. Xflow Trigger Wheel Kit (to be mounted to your engines front pulley) (400). Crank Sensor & 2 Pin EV1 Connector. Wasted Spark Zetec Coil Pack & Zetec 3 Pin Connector. The innovative Nodiz Pro Electronic Ignition System.Fully 3D ignition advance control, out-of-the-box support for most engines, wireless tuning, free Android dashboard application. Ideal for use alongside bike carbs or the more traditional carburettor set-ups. 3D Stand-alone electronic ignition system. 16 Load by 16 Speed Sites, with full 3D interpolation and user definable Speeds/Loads.
Wireless tuning through Bluetooth (USB dongle optional). Tuning by a Serial Port Connection (Gen2). Free Virtual Dashboard Android app.
Support for any Megajolt map through our Megajolt MAP Import feature. Supports 36-1 and 60-2 Trigger Patterns. A wide range of basemaps.
In-built coil drivers, no need for EDIS or other modules. Launch control, Shift Light Output and V-TEC Output. User settable RPM Soft and Hard Cut Rev Limiters. Cranking based advance angle to help start high compression engines. (Using lower speed sections of the map).A programmable Shift Light output. Android app to allow a free digital dashboard. A programmable output based on either RPM i. V-TEC control, coolant temperature i. Fan Control or Intake temperature i.
The NODIZ Pro is a state of the art microprocessor controlled digital stand-alone, fully mappable ignition controller for 4, 6 or 8 cylinder spark ignition engines. It can be used either to replace older distributor based ignition systems for more modern coil packs, or even to allow the running of carburetors on more modern engines which do not feature a distributor drive. Out of the box support for 36-1 (as used on Ford engines such as CVH/Zetecs/Duratecs) and 60-2 trigger patterns (Vauxhall, Peugeot, Renault, Citroen, VW and BMW) means that you wont need to fit an additional trigger wheel and youll have the engine running faster and easier compared to other programmable ignition systems such as Megajolt.
Whether you are using a Ford Zetec, through to a Vauxhall C20XE, Peugeot TU or Renault F4R, everything works better with a Nodiz! Ford Xflow 36-1 trigger disc kit Complete kit with all parts needed to fit a crank sensor to the Ford Crossflow engine.
Includes genuine Marelli crank sensor, disk, bracket and all nuts, bolts, spacers etc required. Everything you need to install a trigger on the Ford Crossflow Engine. The item "Ford X-Flow Crossflow NODIZ Pro Ignition Only ECU Kit -Trigger kit Coil Pack etc" is in sale since Tuesday, August 27, 2019. This item is in the category "Vehicle Parts & Accessories\Car Tuning & Styling\Engine, Tuning & Chips\Other Engine Tuning". The seller is "shopbhp" and is located in Sevenoaks, Kent.
This item can be shipped worldwide.